Hex Rigid Mount Manifolds
Hex Rigid Mount Manifolds mount directly to the pipe stand securing the impulse lines so the transmitter can be installed or removed independently of the piping. They feature a "standard" two or three valve manifold or a blowdown manifold with an integral, welded mounting plate. The secure, welded design allows for fast and easy installation of gauge and differential pressure transmitters on vertical or horizontal stands. Choose from five models to meet your instrumentation requirements:
- HM10: Single Flanged Static Pressure Manifold for Gauge Pressure Instrumentation
- HM13: Single Flanged Three Valve Manifold for Differential Pressure Transmitters
- HM14: Double Flanged Three Valve Manifold for Differential Pressure Transmitters
- HM16: Single FLanged Manifold featuring independent blowdown valves
- HM18: Single Flanged Two Valve Manifold for use with Level Instrumentation
|
|
| A side-by-side comparison shows the advantages of the Hex Rigid Mount approach to transmitter installation... |
 |
 |
|
The conventional method for supporting remote mounting pressure transmitters has been to bracket the transmitter directly to the pipe stand. This often causes delays and problems during initial installation because the system cannot be pipied until the instruments have been delivered. In addition, the transmitter cannot be removed without disconnecting the piping and thus leaving impulse lines unsupported.
|
The Hex Rigid Mount has the manifold, not the transmitter, supporting the piping. On new installations, all piping can be done prior to the arrival of the instruments to save time and money - the transmitter simply bolts to the manifold. The transmitter can be removed and replaced without disturbing any of the piping. |
 Download Brochure |
(Adobe Acrobat Reader Tip: to quickly page through the above brochure use the arrows at the bottom left the Acrobat Reader screen.)
|
